Control and Processing Module (CPM) / Software

Home > Products > Electronics for Bladed Systems > Control and Processing Module / Software

Control and Processing Module / Software

Our Control and Processing Unit (CPM) is a 1U server class PC with high speed data acquisition of the signals and control of the electronics.

Used initially to configure the system and to present the data in values, figures and visual plots and charts: Sample charts are at right.

Up to 10 MHz simultaneous sampling in control and processing modules (CPM) from analogue BPS signal

Built-in data acquisition and software means no analogue data for the user to acquire and analyse

Auto download of sensor calibration means you can never mix your signals
Auto setup—no jumper settings
Sync signal—used to synchronise multiple racks for the pooling of data
Hard disc for data storage and further analysis
5 Series oscillator will allow Ultra Slow Mode Once per rev input (engine speed/blade identification)
Configurable alarm volt-free contacts for basic remote monitoring

Addition of blade vibration monitoring from the same system that gives you the tip clearance (simple software update)
Remote access from Microsoft Windows® or Linux based machines—no software needs to be installed

Designed to be a perfect solution for industrial installations, the CapasiSense SOLO is a “one box” electronic solution. Each CapaciSense SOLO […]

The oscillator drives the sensor with a 2MHz oscillating carrier frequency (typically), the control circuit is then used to keep […]

The demodulator extracts the frequency changes from the oscillator and converts this to a voltage. This voltage is proportional to […]

Our demodulators and AM receivers are housed in a 19″ racks 3U high and come in both full width and […]